Recently I purchased a USB Ethernet adapter (IOGEAR, model GUC210T) to use it in a notebook with Zenwalk 4.2 where it works normally, but it does not work in my Puppy 2.14 booted from cd-rom.
It uses the ASIX AX88172 driver. I also tried to load the driver (for Windows) from the installation cd, but I failed. Then I found that this driver is already supported by Linux kernel driver "usbnet.c" in Linux kernel 2.6.x, then I do not understand what is happening.
Can someone give me a tip to load any driver (with Puppy) for this adapter?
Nacho
-------------------------------------------
PD: These are some features of the adapter:
* Compliant with the Standard Specification of USB 1.1 and 2.0
* IEEE 802.3u 100BASE-T, TX Compatible
* USB to 10/100Mbps Fast Ethernet
* Full/High Speed USB Device with bus power capability
* Support 4 endpoints on USB; full-duplex or half-duplex operation on Fast Ethernet
* Support automatic loading of Ethernet ID, USB Descriptor and Adapter Configuration
* Supports suspended mode and remote wakeup
* Upstream port : USB type A plug; downstream port : RJ45
---------------------------------------
Need driver for IOGEAR GUC210T USB ethernet adapter
Regarding the ASIX usb ethernet adapter
nacho,
To get your asix ethernet card to work, type the following commands in the command line
modprobe usbnet
modprobe asix
This is already explained in the post
http://murga-linux.com/puppy/viewtopic. ... 557&t=8708
Browny.
To get your asix ethernet card to work, type the following commands in the command line
modprobe usbnet
modprobe asix
This is already explained in the post
http://murga-linux.com/puppy/viewtopic. ... 557&t=8708
Browny.
Problem solved
Browny,
Thank you. Now my ethernet connection works perfectly.
Sorry for my newbie question. I see now the simplicity.
nacho
Thank you. Now my ethernet connection works perfectly.
Sorry for my newbie question. I see now the simplicity.
nacho