Bug: Grub and Grub4Dos not working in 5.2.8

[strategic_thinker]

I have been using 5.2.5 for quite a while. I installed 5.2.8 (clean/wipe). But I found that the Grub and Grub4dos installers don't work. Yes, I can go in hack the necessary file. But that's not the point. Please treat this as a bug report. I reverted to 5.2.5. The Grub and Grub4dos installers work fine there.

Machine: Dell Dimension, Intel P4, 2.8 Ghz (Northwood), 2GB ram, Nvidia FX 5500.

Greatly appreciate if you can fix.

Thanks and regards.

[rcrsn51]

Yes, I can go in hack the necessary file.

If you supplied the hack you used, it would make the developer's job easier.

Also, more information than "not working" would be helpful.

I just used Grub4Dos bootloader config in Luci 528 to set up a flash drive and it worked fine.

[strategic_thinker]

I did not "hack" .

When one runs the install, it tells you to enter the 5.2.8 specific text into a *.lst (I think) file. I did not want to do that. That's what I meant.

When I tried the Grub and Grub4Dos installers, they did not work. In 5.2.5 either program handles the bootting up OS choice with ease.

[rcrsn51]

When I tried the Grub and Grub4Dos installers, they did not work..

Once again, exactly how did they "not work"? Are you installing to a hard drive or a flash drive? Are you doing a full or frugal install?

Submitting a "bug report" with zero details helps no one.

[strategic_thinker]

Sorry ! My bad.

I re-installed 5.2.8 and was successful in installing grub4dos. No issues.
I must have hit some wrong buttons.

Thanks and regards.