How to use Bluetooth speaker with Tahrpup PAE?
Posted: Sun 19 Jun 2016, 09:49
Dear all,
I am new therefore please excuse if I have choiced the wrong place to set up my problem as well please excuse for my english....
I want to use Puppy "Tharpuppy 6.0.5" PAE to use my older laptop major only for music playing.
I want to use my Panasonic Bluetooth speaker, which already works fine unter Debian..
As far as I can see, I installed all necessary bluetooth applications.
including pulseadio 4.0, pulseaudio-module-bluetooth
and pavucontrol.
Blueman shows the speaker with the correct name SC-NE3.
During the connection Blueman is also asking for connect to AD2D sink.
After several seconds I got the message: device successfull added but conecection failed.
If I click an "connect to audio device" I can see "Stream setup failed"
What does I make wrong? I have investigate some web sides but nothing helps.
Any suggestion for me?
Thanks a lot in advance
Best regards
Dietmar
I am new therefore please excuse if I have choiced the wrong place to set up my problem as well please excuse for my english....
I want to use Puppy "Tharpuppy 6.0.5" PAE to use my older laptop major only for music playing.
I want to use my Panasonic Bluetooth speaker, which already works fine unter Debian..
As far as I can see, I installed all necessary bluetooth applications.
including pulseadio 4.0, pulseaudio-module-bluetooth
and pavucontrol.
Blueman shows the speaker with the correct name SC-NE3.
During the connection Blueman is also asking for connect to AD2D sink.
After several seconds I got the message: device successfull added but conecection failed.
If I click an "connect to audio device" I can see "Stream setup failed"
What does I make wrong? I have investigate some web sides but nothing helps.
Any suggestion for me?
Thanks a lot in advance
Best regards
Dietmar